6. BIOS Setup
SPI-8150-LVA, SPI-8151-LVA
61
Function description Choice
KB Power of Password
When the value of “Power On Function” is
setted to “password”, Set your password.
Enter Password
Onboard FDC Controller
Select Enabled if your system has a floppy
disk controller (FDC) installed on the system
board and you wish to use it. If you install
and-in FDC or the system has no floppy
drive, select Disabled in this field.
Onboard Serial Port 1/Port 2
Select an address and corresponding
interrupt for the first and second serial ports.
UART Mode Select
Enables you to select the infrare
communication protocol:
Standard (default) | IrDA | ASKIR, IrDA is
Hewlett Packard's infrared communicatio
protocol with a maximum baud rate up to
115.2K
ps. ASKIR is Sharp's infrare
communication protocol with a maximu
baud rate up to 57.6K bps.
RxD, TxD Active
Defines the voltage level for Infrared module
RxD (receive) mode and TxD (transmit)
mode. This setting has to match the
requirements of the infrared module used in
the system.
IR Transmission Delay
When set to "Enabled", utilizes the
capability of the Keyboard computer to allow
faster infrared transmission rates.
To Next Page
Loading...
Need help?
General
