User's Manual CS1171 Hand-Held Programmer
Page 33 of 56 Control Solutions LLC
When set to On, cycles the battery status LEDs from the bottom
segment to the top segment, with charge complete status
indicated by flashing the top segment. Setting Seq chrg led to Off
disables this feature. The display type used, determines how this
option indicates a charge complete status.
When set to On, saves real-time motor compensation (boost)
values and automatically reapplies them when stopping and
restarting on an incline to prevent rollback. Boost values are not
saved through a key switch power cycle.
When set to On, while asserting a Quickstop, flashes the status
LED on the controller at a constant 2Hz rate. If equipped with a
display unit, also flashes the battery LEDs.
When set to On or Off, it allows the status LED to display the
appropriate error code.
When set to On, with Quickstop asserted, allows the status LED to
display the appropriate error code.
When set to On, configures the controller to respond to throttle
from an Enhanced Deluxe Display.
When set to On, configures the controller to respond to an analog
throttle directly connected to TPOTC input.
When set to On, configures the controller to respond to the speed
control pot from an Enhanced Deluxe Display as a throttle.
When set to On while Sertht throt is enabled, inverts the
operation of the response to the speed control.
Speeds up the activation of the EM brake when stopping on an
incline. It should be set low enough for acceptable stopping
performance on a nominal incline, but should not be set so low
that the brake prematurely engages when stopping on flat ground
or grass.
When set to On, makes it necessary to activate the throttle
mechanism twice to make the vehicle drive.
An intelligent display with the ability to visually
represent real time data is required to use Seq
chrg led.
To Next Page
Loading...