CONTROL SOLUTIONS CS1171 - Functions Sub-Menu

CS1171 Hand-Held Programmer User's Manual
Control Solutions LLC Page 38 of 56
Functions Sub-Menu
Parameter
Description
Clr flt log
Clears all faults from the controller’s Fault log.
Recall Init
Every time the HHP is powered up successfully, it stores the
controller’s current configuration. After changing various
parameters, but before powering down the Hand-Held
Programmer, this option can restore the controller’s original
configuration of all parameters. If the HHP power is turned off or
lost, memory of the controller’s configuration at the time of the last
power-up is lost as well.
Recall Fact
Restores the factory default configuration of all parameters, if
available (See Troubleshooting and Diagnostics on page 51 for
details).
Save to Mem1
Stores the current configuration of all parameters to the Hand-Held
Programmer’s non-volatile memory. Overwrites any configuration
currently stored. Values are not destroyed after recalling from
memory to allow program-cloning of controllers. Values are only
overwritten when Save to Mem1 is used again.
Recall Mem1
Restores the Hand-Held Programmer's stored configuration of all
parameters from Memory 1.
Save to Mem2
Functions the same as Save to Mem1 but stores to Mem2.
Recall Mem2
Restores the Hand-Held Programmer's stored configuration of all
parameters from Mem2.
Save to Mem3
Functions the same as Save to Mem1 but stores to Mem3.
Recall Mem3
Restores the Hand-Held Programmer's stored configuration of all
parameters from Mem3.
Save to Mem4
Functions the same as Save to Mem1 but stores to Mem4.
Recall Mem4
Restores the Hand-Held Programmer's stored configuration of all
parameters from Mem4.
Save to Mem5
Functions the same as Save to Mem1 but stores to Mem5.
Use this feature cautiously when program-cloning,
so as not to inadvertently program many
controllers with undesired values.