Control Techniques UD53 User Manual

UD53 User Guide
Issue code: 53nu3
16
6 Related Parameters
6.1 Introduction
The parameters listed in this chapter are used for programming and
monitoring the UD53. Refer to the Unidrive User Guide for programming
instructions.
Warning
Before attempting to adjust any parameters, refer to the
Warnings and Notes at the beginning of Chapter 3 Setting up
the Drive in the Unidrive User Guide.
6.2 Programmable software
Key
Type of parameter
RO Read-only
RW Read–write
...select Select from two settings
...enable Make or allow a function to operate
...disable Stop or disallow a function from operating
...indicator The value can only be read
Limitations of use
S The new parameter-value is saved when the
AC supply is
disconnected from the Drive.
P Protected parameter; the parameter cannot be used as the
destination parameter for a programmable input.
Range
Bi Variable parameter having bipolar value range.
Uni Variable parameter having unipolar value range.
Bit Bit parameter
Symbols
ð Default value
ô Range of values
~ Indicates a range of values
(in the case of bit parameters, ~ indicates or).

Control Techniques UD53 Specifications

General

Brand	Control Techniques
Model	UD53
Category	Control Unit
Language	English