3.
Cut the fastener holding the stretch plastic.
4.
■
Remove all the corner pieces one at a time by lifting up
the top cover briefly at each corner.
■
Then take the top cover off completely.
■
Remove the customer documentation from the top of the
appliance.
■
Remove any additional protective films, cardboard pack‐
aging or transport securing devices etc. completely from
the appliance.
5.
Read first:
■
This step 5 is not needed for the floor-standing marine
model.
Undo the screw fastenings on the slides and pull the slides
out. Keep the screws and slides to hand.
Additional information:
■
The slides will be used as a ramp for the appliance.
6.
Inspect the appliance again for damage.
If you suspect the appliance has been damaged during
transit, notify your dealer/carrier immediately. Please notify
the manufacturer in writing within three days.
Never install or put into service a damaged appliance un‐
der any circumstances.
5 Setting up the appliance
55
To Next Page
Loading...
