Convotherm OGS 6.10 Service Handbook

Service Handbook OEB/OES/OGB/OGS
6.15 Sealing the Corners on the Door Gasket Frame
Only for table units.
Page 1 / 1
Check:
Water drops on the lower corners of the unit because it is not water-tight.
Instructions:
1. Remove the hygienic door gasket.
2. Dry both lower corners of the door gasket frame.
3. Clean both corners with alcohol or acetone.
4. Re-seal the corners with silicone E 43, Part No. 700 40 20.
Safety: Important
5. Allow the silicone 24 hours to harden (vulcanisation time) before putting the
door gasket back in!
Silicone glue
Inner casing
Outer casing
AS/11-2011 6_15e_Sealing the Corners on the Door Gasket Frame_b

Convotherm OGS 6.10 Specifications

General

Brand	Convotherm
Model	OGS 6.10
Category	Kitchen Appliances
Language	English