4. To Install the Gasket Plate (22): Simply line up the Gasket Plate (22) with the rubber
knob in the center and push downwards until you hear a "Click."
5. How to Remove and Install the Rubber Seal Ring (20): In order to remove the Rubber
Seal Ring (20), the Gasket Plate (22) must first be removed. Then simply remove the
Rubber Seal Ring (20) from around the edge of the Gasket Plate (22). To Install the
Rubber Seal Ring (20) onto the Gasket Plate (22), place the Rubber Seal Ring (20)
onto the edge of the Gasket Plate (22) until it is securely attached to the Gasket
Plate (22). The Rubber Seal Ring (20) should fit around the outside of the entire
Gasket Plate (22).
*Note: Make sure the Rubber Seal Ring (20) is firmly attached to the Gasket Plate
(22) before re-installing the Gasket Plate (22) onto the Lid (2).
PREPARING YOUR PRESSURE COOKER
1. Opening the lid: Hold the handle (1) firmly, turn the lid (2) clockwise until it loosens
and lift vertically (See Figures 5-6).
2. Remove the inner pot (6) and add desired ingredients. The amount of water and
food should not exceed 2/3 of the height of the Inner Pot (6) (Figure 7); this is
indicated by the MAX marking on the Inner Pot (6). For food that will expand in
water, the level should not exceed 1/2 of the Inner Pot (6) (Figure 8). The minimum
level for cooking is 1/5 of the Inner Pot (6) (Figure 9).
To Next Page
Loading...
