BEFORE FIRST USE
1. Remove all packaging materials such as cardboard, plastics, Styrofoam and
literature.
2. Clean all parts by wiping with a soft, damp cloth or sponge and dry thoroughly.
LID ASSEMBLY:
1. How to open the lid: Hold the handle (1) firmly, turn the lid (2) clockwise until it
loosens and lift vertically (Figures 1-2).
Note: For new units, the seal of the lid (2) may be slightly stronger than normal and
may be slightly difficult to unlock. Once the lid (2) has been opened and closed
several times, it will loosen.
2. How to close the lid: Hold the handle (1) and close it downwards at the Opened Lid
position (Figure 3). Turn counter-clockwise until you reach the Closed Lid position
(Figure 4).
3. How to Remove the Gasket Plate (22): Be very careful when removing the Gasket
Plate (22) as the sides of the Lid (2) Interior can be sharp. To remove the Gasket
Plate, pull upwards by grasping the sides of the Gasket Plate (22) or by pulling
upwards on the knob located in the center of the Gasket Plate (22).
To Next Page
Loading...
