CoolAutomation CoolMasterNet - Page 36

ASCII I/F
CoolMasterNet PRM Rev 0.7
36
www.coolautomation.com
© 2017 CoolAutomation
MH
0.5ºC
LG
0.5ºC
HT
1ºC
GR
1ºC
MD,CG,KT,TR
1ºC
TI
1ºC
MT
1ºC
The deg setting (see set command) defines which temperature scale Celsius or Fahrenheit is used for <TEMP>
and <TEMP.d> parameters value.
EXAMPLE
Set Indoor Unit 102 on line L1 Set Temperature to 23º
>temp L1.102 23
OK
Decrease all Indoor Units on line L2 Set Temperature by 2º
>temp L2* -2
OK
Set all Indoor Units on line L2 Set Temperature to 24.5º
>temp L2* 24.5
OK
Set all Indoor Units Set Temperature to 22º
>temp 22
OK
fspeed
SYNOPSIS
fspeed [UID] <v,V|l,L|m,M|h,H|t,T|a,A>
DESCRIPTION
Set Indoor Unit(s) Fan Speed to:
· v, V - very low or quiet
· l, L - low
· m, M - medium
· h, H - high
· t, T - top or very high
· a, A - auto
Not all Indoor Units support Fan Speed options listed above. Specific Fan Speeds support depend on specific
Indoor Unit capabilities. If requested Fan Speed is not supported by Indoor Unit(s) fspeed command will have
no effect.
EXAMPLE
Set Indoor Unit 102 on line L1 Fan Speed to low
>fspeed L1.102 l
OK
Set all Indoor Units on Line L2 Fan Speed to high
>fspeed L2* h
OK
Set all Indoor Units Fan Speed to medium
>fspeed m
OK