Coolmay CX3G - Page 68

CX3G/FX3GC PLC Programming manual
www.coolmayplc.com
66
MAC address
R23804~R23806
Local IP address
R23807 R23808
Target IP address
R23810 R23811
Terminal
R23812
Default as 502
RD3A/WR3A command cycling
times
R23813
MODBUS time-out period
R23814
InfoPacketSend
R23815
26235 and higher version
InfoPacketReceive
R23816
26235 and higher version
M8193：=1 Represents that there is a network chip, network preparation
M8197：=1 Write network address, automatic reset (Not support 26231 version,
you can write the above parameters and then restart).
M8062：=1 Represents MODBUS timeout, MODBUS_TCP is used.
M8063：=1 Represents IP address is conflict.
D8395：Switch between Mitsubishi function and MODBUS_TCP
D8395=0：Mitsubishi function
D8395=1：MODBUS_UPD Slave
D8395=2：MODBUS_UPD Master
D8395=3：MODBUS_TCP Slave
D8395=4：MODBUS_TCP Master
D8397：While using ADPRW command, it needs to set D8397 to 3 when using
MODBUS_TCP.(26232 and higher version)
R23800,23801 is the router address. Default:192 .168. 1 .1. Namely
R23800=0XC0A8,R23801=0X0101.
R23802,23803 is the mask address,Default:0 .0. 0 .0. Namely
R23802=0,R23803=0。
R23804~23806 is the MAC address,is generated by the system, basically no