6
Option 1-1-4:
Telecommand Test
This option enables you to test a
telecommand, or identify an unknown
telecommand.
User 1 Menu 1
Test Menu
1. Press [ to select this option.
Test Menu 4
Telecmd Test
2. Use | or ¬, or press 4 to select
Telecmd Test, then press [.
2:01:1 RNode
Martha’s
3. Either:
Use | or ¬ to select the telecommand
you want to test, and press [.
OR:
Press any button on the telecommand
you are testing and press [.
2:01:3 RNode
9(5) Bat-H
The top line of the display shows the
number of the telecommand you are
testing. The bottom line of the display
shows (from left to right):
• Current signal strength.
• Previous lowest signal strength (in
brackets).
• ”Bat-” (for Battery) followed by H for
healthy or L for low.
4. Either:
Press ] to exit, leaving the record of
lowest signal strength as it is.
OR:
Press [ to exit, resetting the record of
lowest signal strength to the current
signal strength, ready to record a new
value.
To Next Page
Loading...
