7
Option 1-2: Omitting Zones
Sometimes you may need to omit zones
when you set your ward (or wards); for
example, if a zone is to remain occupied
while the rest of the ward is set. This option
enables you to select which zones to omit.
Z
When the system is unset, any zones
already omitted are re-instated. This
prevents zones from being omitted
inadvertently.
Z
You can omit only zones that the installer
has set up as omittable (Engineer option
1-1).
User 1 Menu 2
Omit Zones
1. Press [ to select this option.
0001 is Armed
2. Select the zone to omit by using | or ¬,
or by entering the four-digit zone
number. Refer to page 53 for details of
zone numbering.
0002 is Armed
3. Press r to change the omit status of the
zone ("Omitted" indicates that the zone
will be omitted).
4. Press [ to view the next zone, or ] to
exit.
To Next Page
Loading...
