Introduction
Service Information S280-70-11 provides disassembly,
reassembly, and testing instructions for the Kyle
®
Form 6
recloser control.
Read This Manual First
Read and understand the contents of this manual and fol-
low all locally approved procedures and safety practices
before installing or operating this equipment.
Additional Information
These instructions cannot cover all details or variations in
the equipment, procedures, or process described, nor
provide directions for meeting every possible contin-
gency during installation, operation, or maintenance. For
additional information, contact your Cooper Power
Systems sales representative.
ANSI Standards
Kyle reclosers are designed and tested in accordance
with the following ANSI standards: C37.60 and C37.85
and ANSI Guide C37.61.
Quality Standards
ISO 9001:2000-certified quality management system
Acceptance and
Initial Inspection
Each unit is in good condition at the factory and when
accepted by the carrier for shipment.
Upon receipt, inspect the carton for signs of damage.
Unpack the unit(s) and inspect it thoroughly for damage
incurred during shipment. If damage is discovered, file a
claim with the carrier immediately.
Handling and Storage
Be careful during handling and storage of the unit to min-
imize the possibility of damage. If the unit is to be stored
for any length of time prior to installation, provide a clean,
dry storage area.
Description
Service Information S280-70-11 provides disassembly,
reassembly, and testing instructions for the Form 6 Rack
Mount, Yard Mount, Pole Mount, and Triple-Single Pole
Mount recloser controls.
For additional information on installing the control,
removing the control from service, and control testing
procedures, refer to the appropriate instructions:
• Service Information S280-70-1 Form 6 Rack Mount
Recloser Control Installation and Operation
Instructions
• Service Information S280-70-2 Form 6 Yard Mount
Recloser Control Installation and Operation
Instructions
• Service Information S280-70-3 Form 6 Pole Mount
Recloser Control installation and Operation
Instructions
• Service Information S280-70-7 Form 6 Triple-Single
Pole Mount Recloser Control Installation and
Operation Instructions
S280-70-11
3
To Next Page
Loading...