Corema GAMMA 250 - Default Chapter; Table of Contents

3
Dear customer,
we congratulate you for choosing a high quality product
which will surely satisfy your expectations.
With our thanks for choosing us,
we kindly invite you to examine the present operating
instructions manual before operating your new device.
SUMMARY
WARNING:
GENERAL/MECHANICAL DANGEROUS
DANGER VOLTAGE
A TEXT IN UPPER-CASE, IDENTIFIED BY ONE OF THE SYMBOLS ABOVE, CONTAINS INSTRUCTIONS
THAT, IF NOT FOLLOWED, MAY CAUSE HARM TO PEOPLE.
A text in lower-case, identified by this symbol, contains instructions that, if not followed, could cause
damages or malfunctions to the device, or falls in its quality.
1 IMPORTANT SAFETY SUGGESTIONS AND
PRECAUTIONS ...................................................... 4
2 SAFETY DEVICES .................................................. 5
2.1 Lid's magnetic sensor ..................................... 5
2.2 Extraction door's grill....................................... 5
3 TECHNICAL DATA.................................................. 6
3.1 Technical data plate and CE marking .............. 6
3.2 Acoustic pressure level ................................... 6
4 CARRYING AND UNPACKING ............................... 6
4.1 Transportation of the packed machine
(floor models) .................................................. 7
4.2 Unpacking ....................................................... 7
5 INSTALLATION ...................................................... 7
5.1 Placing and check of the parts ........................ 8
5.2 Machine’s parts reassembling ......................... 8
5.3 Electrical connection....................................... 8
5.4 Connection to the water network (devices with
water condensation) .......................................10
5.5 Initial functioning check ..................................10
6 MACHINE’S OPERATION......................................11
6.1 Warnings ....................................................... 11
6.2 Commands and indicators..............................12
6.3 Production .....................................................14
7 WASHING .............................................................16
7.1 Simple washing and hygienisation .................16
7.2 Disassembling of the parts.............................17
7.3 Accurate washing ..........................................17
7.4 Reassembly...................................................18
8 MAINTENANCE .....................................................19
8.1 Maintenance during the components
disassembling................................................19
8.2 Check of safety devices .................................19
8.3 Yearly maintenance .......................................20
9 PERIODS OF INACTIVITY ....................................20
10 MALFUNCTIONS ..................................................20