English
Operating instructions
5
2SAFETY DEVICES
DO NOT ALTER THE SAFETY DEVICES AND DO NOT UTILIZE THE MACHINE IF THE SAFETY DEVICES
ARE DAMAGED OR MALFUNCTIONING.
THE MANUFACTURER IS NOT RESPONSIBLE FOR POSSIBLE DAMAGES CAUSED TO PEOPLE OR OB-
JECTS BY THE ALTERING OR BYPASSING SUCH DEVICES OR RELATIVE CIRCUITS.
2.1 Lid's magnetic sensor
This safety device, featuring an approved type magnet [1] and a magnetic contact [2]
avoids accidents caused by the accidental starting of the beater when the lid is open.
In consequence the device can't operate when the lid is open, and if it is opened
during its functioning the beater immediately stops.
In any case the lid's magnetic sensor MUST NOT be considered a control to be used
for the normal stop of the device.
DURING THE NORMAL USE, THE DEVICE MUST BE STOPPED ONLY
BY USING THE BUTTONS ON THE CONTROL KEYPAD, AND NOT BY
OPENING THE LID.
The magnet [1] and the magnetic contact [2] MUST be assembled as follows: the grooves [3] and the stencilled semicircle
[5] on the bottom of the magneto [1] must coincide with the grooves [4] (marked by a white line down the side) and the
stencilled semicircle [6] on top of the magnetic contact [2]. The device will not work unless all parts have been
correctly assembled in accordance with these instructions.
2.2 Extraction door's grill
In large-sized models, supplied with extraction door, a fixed protection grill [3] prevents,
as far as possible, fingers or objects from being ACCIDENTALLY inserted in the chute.
In order to insure normal operation it is not possible to adjust the fixed grill as to prevent
fingers and objects from being VOLUNTARILY inserted through the extraction chute
(according to Machines Directive 89/392/CEE and ensuing modifications, Ap-
pendix I, Art. 1.1.2.b, 3
rd
paragraph).
RESIDUAL HAZARD: DO NOT FOR ANY REASON INSERT
FINGERS
OR OBJECTS THROUGH THE GRILL OF THE EX-
TRACTION DOOR WHEN THE MACHINE IS IN FUNCTION.
The user is warned of the above RESIDUAL HAZARD (89/392/CEE and ensuing
modifications, Appendix. 1, Art. 1.1.2.b, 3
rd
paragraph and 1.7.2) by a plate [30]
affixed next to the extraction chute.
DO NOT HANDLE OR REMOVE THE GRILL [3] FROM ITS SET-
TING IN THE EXTRACTION DOOR!
To Next Page
Loading...