EM 9250 Operator’s manual 117
UK
15.5. SET UP - WARNING OPT
The machine indicates the need to perform an unbalance optimisation procedure (OPT)
with the flashing LED on the display panel.
Proceed as follows to disable this function:
- press the key
- use the keys to search for SEt UP
- press the key to confirm
- use the keys to search for OPt on (OPt oFF if disabled)
- press the key to change the setting:
OPt on to activate the display of the alarm indicator light
or OPt oFF to deactivate the display of the alarm indicator light
- press the key to confirm and exit.
15.6. SET UP - RIM DIAMETER DISPLAY
UNIT OF MEASUREMENT
The machine may be set to display the rim diameter unit of measurement in inches or
millimetres.
Proceed as follows to modify this configuration:
- press the key
- use the keys to search for SEt UP
- press the key to confirm
- use the keys to search for -d- in (-d- MM if the display in millimetres
is enabled)
- press the key to change the setting:
To Next Page
