118 EM 9250 Operator’s manual
-d- MM to activate the display in millimetres
or -d- in to activate the display in inches
- press the key to confirm and exit.
15.7. SET UP - RIM WIDTH DISPLAY UNIT
OF MEASUREMENT
The machine may be set to display the rim width unit of measurement in inches or mil-
limetres.
Proceed as follows to modify this configuration:
- press the key
- use the keys to search for SEt UP
- press the key to confirm
- use the keys to search for -b- in (-b- MM if the display in millimetres
is enabled)
- press the key to change the setting:
-b- MM to activate the display in millimetres
or -b- in to activate the display in inches
- press the key to confirm and exit.
15.8. SET UP – ACOUSTIC SIGNAL
The machine can be configured to beep each time a key is pressed on the keypad.
Proceed as follows to modify this configuration:
- press the key
- use the keys to search for SEt UP
To Next Page
