Corghi HD 1300 - Preliminary Checks; During Use

HD 1300 / HD 1300 A Operator Manual 79
EN
PRELIMINARY CHECKS
Before starting to work, carefully check that all machine components, particularly rub-
ber or plastic parts, are in place, in good condition and operate correctly. If damage or
excessive wear is found during the inspection phase, replace or repair the component
immediately regardless of the amount of damage or wear.
DURING USE
If strange or unusual noises are heard, if a component or system is not operating correctly
or if you observe anything unusual, immediately stop using the machine.
•Identifythecauseandimplementallthenecessarycorrectivemeasures.
•Contactyoursupervisorifnecessary.
Make sure that all other people are positioned at least 6 metres (20 feet) from the machine.
To stop the machine under emergency conditions:
•disconnectthepowersupplyplug;
Each machine has a data plate Fig. 1, with information about the machine and some
technical data.
As well as the manufacturer’s details, it
indicates:
Mod. - Machine model;
V - power supply voltage in Volts;
A - Input voltage in Amperes;
kW - Absorbed power in kW;
Hz - Frequency in Hz;
Ph - Number of phases;
bar - Operating pressure in bar;
Serial N. - the machine serial number;
ISO 9001 - company Quality System Certification;
EC - EC marking.
TRANSPORT, STORAGE AND HANDLING
Conditions for transporting the machine
The tyre changer must be transported in its
original packaging and stowed in the position
shown on the packaging itself.
- Size of packages (Fig. 2):
•Width(B.........................................2280mm
•Depth(A).........................................1700mm
•Height(C)........................................1030mm
42015 - Correggio (RE) Italy
ISO9001
Code
Serial N.
X-XXXXXXXX/XX - XX
XXXXXXXXX
QUAL. SYS. CERTIFIED
ANNO DI COSTRUZIONE /
MANUFACTURED
Mod.
V
A
kW
Hz
Ph
bar/psi
Port.max
1
A
B
C
2