What causes the carbonator pump to short cycle with every drink drawn from my Cornelius FlavorFusion Beverage Dispenser?
If the carbonator pump is short cycling, it could be that the lower liquid level probe reads “dry” while the upper probe reads “wet”. Check the color of leads going to probes. Black should go to bottom probe and white to top probe. Reverse if incorrect.
What causes the carbonator tank to overfill and overflow in my Cornelius Beverage Dispenser?
A carbonator tank that overfills and overflows may be due to several issues. First, check for poor electrical connections between the carbonator tank and the main control board, inspecting connections at the carbonator tank and at connector J4 on the main control board. Second, look for broken wires between the carbonator tank and the main control board, replacing the wire harness if necessary. Finally, defective liquid level probes can cause this issue, so replace both liquid level probes.
General| Brand | Cornelius |
|---|---|
| Model | FlavorFusion Series |
| Category | Beverage Dispenser |
| Language | English |
Comprehensive safety guidelines and warnings for unit operation and maintenance, including overview and alert recognition.
Critical safety information regarding CO2 gas hazards, leak prevention, and the dangers of exposure.
Critical warning for installers regarding water supply protection, backflow prevention, and code compliance.
Common dispenser issues, their causes, and recommended remedies for operational problems.
Troubleshooting guide for carbonator pump, tank, and CO2 related problems.
Guide to interpreting control board LED states and sensor inputs for diagnostics.
To Next Page