What to do if I see a Cabinet Temperature Error on my Cornelius HELIX?
If your Cornelius Dispenser displays a Cabinet Temperature Error, check to ensure the door is closed properly and the gasket is sealing correctly.
What does SMART Gateway Communications Error mean on Cornelius HELIX Dispenser?
If the Cornelius Dispenser displays a SMART Gateway Communications Error, the Smart Gateway will not operate, but other unit functionality will operate normally.
What should I do if my Cornelius HELIX displays a Sanitation Schedule Alarm?
If your Cornelius Dispenser displays a Sanitation Schedule Alarm, acknowledge it by selecting the pop-up and then perform a sanitation cycle.
How to reset Blender Reset Alarm on Cornelius HELIX Dispenser?
To address a Blender Reset Alarm on the Cornelius Dispenser, use the corresponding button to attempt to recover the blender. This usually requires restarting the current process. The log will show the blender error and the specific condition.
What to do if my Cornelius Commercial Food Equipment has no activity at all?
If your Cornelius Commercial Food Equipment shows no activity, there might be several reasons. First, ensure the unit is properly plugged in and the cable is securely connected in the E-box. Second, verify that there is power to the branch circuit by checking the fuse or breaker. If these steps don't resolve the issue, inspect the keypad for proper connection or consider replacing it. As a last resort, the control board might be faulty and need replacement.
What to do if Cornelius Commercial Food Equipment LEDs are on but there is no motor activity?
If the front panel LEDs are on, but there is no motor activity or response from your Cornelius Commercial Food Equipment, consider the following: * Check that the faceplate is in the proper mounted position and adjust as needed. * Check for excessive refrigeration pressure and correct it. * Check connections and the transformer in the E-box. * Ensure there isn't a bad or missing cable connection; connect or replace the cable if needed. * The control board may be bad and needs replacing.
What to do if my Cornelius Commercial Food Equipment product does not dispense?
If your Cornelius Commercial Food Equipment isn't dispensing product, check the following: * Check the connections to the dispense switch and correct as needed. * Inspect the dispense switch itself; adjust or replace it if it is bad or mis-located. * The control board may be faulty and require replacement.
Why is there no condenser fan or compressor in my Cornelius Commercial Food Equipment?
If your Cornelius Commercial Food Equipment has no condenser fan or compressor, check the connections, contactor, and transformer in the E-box and correct as necessary.
Why is the compressor not running but the condenser fan runs on my Cornelius Commercial Food Equipment?
If the condenser fan runs but the compressor does not on your Cornelius Commercial Food Equipment, check the connections at the contactor, capacitors, start relay, and compressor, correcting as needed. If the connections are good, the start relay, capacitor(s), compressor, or contactor may need to be replaced.
What to do if the compressor runs but there is no condenser fan in my Cornelius Commercial Food Equipment?
If the compressor runs but there is no condenser fan on your Cornelius Commercial Food Equipment, check the connections at the contactor and fan, correcting any issues. If the connections are secure, the condenser fan or contactor may need to be replaced.
To Next Page
General