Installation Preparation
Unpacking and Inspecting
This section discusses the procedures for receiving the shipment, inspecting the packing container, unpacking,
and inspecting the device.
Inspecting the Packing Container
Handle the packing container carefully. Inspect the packing container immediately on arrival at the installation
site to verify that no obvious damage occurred during shipment. Ensure that the container is sound and that
the waterproof and vibration warning notices are still obvious. If possible, always inspect the equipment in the
presence of the delivery person.
If any damage is observed:
1.
Do not open or unpack the container.
2.
Immediately contact the transportation carrier and notify them of the damage.
3.
File a claim with the carrier once you determine the extent of any damage.
4.
Return it to CORNING’s nearest RMA facility and contact CORNING for RMA processing. ‘
Unpacking the Device
If the container appears to be in satisfactory condition:
1.
Ensure both user and supplier representatives are in attendance during shipment inspection.
2.
Confirm where you will store the device.
3.
Ensure procedures are in place to handle the device and other equipment properly.
4.
Ensure the following tools are available to unpack the shipment: hammer, paper cutter, and crowbar.
5.
Open the packing container carefully. The device is contained in a protective package inside the packing container;
however, caution is still necessary so as not to damage the internal package and device.
6.
Remove the internal package from the packing container.
7.
Unpack the device from the internal package carefully.
Verifying the Contents
To verify the contents of the package:
1.
Verify that the contents and quantities agree with the Delivery Packing List.
2.
Check the device model against the Delivery Packing List.
3.
Notify CORNING immediately if any discrepancies are discovered, to verify whether the complete and correct
shipment has been received.
To Next Page
Loading...