use the ► button to toggle to the OFF position.
Press OK to save the settings.
FLASH POWER: You can set the Flash Power
depending on your set up. If most of the subjects
are going to be inside 20’, use the LOW setting. If
you need extended night vision, choose the HIGH
option. Press the ▼ button to highlight the Flash
Power option. Use the ► button to navigate
between the two different settings. Press OK to
save the settings.
PASSWORD: Press the ▼ button to highlight the
Password option. You can password protect your
camera with this setting. The default setting is OFF.
Make sure you write down your password or store
it in your phone so you don’t lose it. If you set this
option to ON, you will not be able to access your
camera without the password. This is a very
important security feature. To turn the password
ON, press the ► button to toggle to ON and press
OK. You will see the following screen: (Figure 18).
To Next Page
Loading...
