Setting up the wireless network:
NET tab:
While finding the network you will see the words
Searching Signal in red on the screen. The camera
will then say Connecting to Server as it is
connecting to the server. Once you see 1X RTT /
EVDO in the top right corner, you are ready to move
on. Under the NET tab, scroll down to Activation
and press OK. Your camera may take several
minutes to activate on the Verizon network.
Note: If your camera says Activation Failed, then
you are in a roaming area and will have to move to
a Verizon home network to activate your camera.
For a full list of zip codes in roaming areas, please
visit our website and search the coverage map.
Quick Tip: If your camera says Connection Failed,
turn the camera OFF then back ON. (Power Cycle.)
To Next Page
Loading...
