Anytime your camera needs a firmware update, it
will be automatically pushed to your camera. When
you go check your camera, we encourage you to
scroll to the NET Tab and download the latest
firmware version in case there’s been an update.
Then take out your SD card, lock it and put it in your
camera. Turn your camera onto setup, scroll to the
SYS tab and scroll down to default set. Press OK.
Then turn your camera off, unlock your SD card and
put in back in your camera.
Important Note: Anytime you make changes
directly to the camera, press OK to save the
changes on your camera and the press the ◄ to
sync the changes directly to the web portal.
Sending a test photo:
This is a great way to make sure that your camera is
working properly before leaving your camera set up
remotely.
To Next Page
Loading...
