overwritten. If the overwrite function is off, the
camera will not continue to send pictures once the
SD card is full.
The default for this option is OFF. If you want to
change this, Press the ▼ button to highlight the
Over Write option and then press the ► button to
toggle the setting to ON. Press OK to save the
setting.
Formatting the SD card:
Turn the camera onto the setup mode. Press the
menu button, then ►button 3 times to highlight
the SYS tab.
Navigate down by pressing the ▼ button
repeatedly until the FORMAT option is highlighted
and press OK. You will see the screen shots shown
below (Figure 19 & 20). Press the ◄ button to
highlight YES and press OK. Your SD card is now
formatted.
To Next Page
Loading...
