Coway CHP-671R/L - Product installation; Installation Method; Installation Precautions

Product installation
Coway co., Ltd
2-1
2. Product installation
2-1 Installation method
2-1-1 Precautions on installation
Precautions
• Thispurifier'stankcapacityissuitableforbusinessuse.
• Installtheproductbasesoitisevenandfirmlyinplace.
• Donotinstallindirectsunlight,inplaceswherethetemperaturedropsbelowzero,
orinveryhumidplaces.
• Checktheproductmanualagainbeforereinstallingormovingthepurifier.
• Onlyconnectthepowercordtothevoltageratingthatmatchesitontherating
plate.Checkthevoltagebeforeconnectingthepowercordtothewalloutlet.
• Thesourcewaterhosemustbeconnectedtoacoldwaterpipe.
- Thefiltermaybedamagedifconnectedtohotwaterof40°Corhotter.
• Immediatelyafterinstallation,disposeofatleasttwofulltanksofstoredwater
whilethestoragetankisfullbeforeusingthepurifier.
• Usenewfiltersonlyafterwashing.(DuringinstallationandA/Sexchange)
- Plussedimentfilter:Installafterwashingwithsourcewaterforabout
10seconds.
- Pre-carbonfilter:Installinreverseandinstallafterwashingwithsourcewater
forabout3minutes.
- Membrane(RO)filter:Installthefilteredwatervalveafterwashingwithsource
waterforabout5minutes.
- Nanotrap(R)filter:Installafterwashingwithsourcewaterforabout3minutes.
- PlusInno-Sensefilter:Installwithnoseparateflushing.
- PlusInno-Sensefilter(D):Installwithnoseparateflushing.
Installation
water pressure
• Thesourcewaterpressuremustbeatleast138kPaforthewatervolumeand
watersystemtooperatesmoothly.
Installation
distance
• Sourcewaterpressureof138kPaorless:Installwithinaheightof3manda
distanceof5m.
• Sourcewaterpressureof138kPaormore:Installwithinaheightof3manda
distanceof25m.