COX EC80 - Profile Management

Prole
April 2019CXX-UM-03060-EN-01Page 22
Establish Link Via Ethernet
If the flow processor in use is capable of Ethernet communication you can connect
to the PC with an ethernet cable.
To establish communications:
1. Check the Use TCP/IP box.
2. Type the IP Address for the connected ow processor.
3. View the Status area for connection info.
PROFILE
A profile is all the information that is programmed into the software, including
Linearization tables, liquid properties, input and output settings, and others. You
can use a profile to program the EC80 Flow Processor. You can also upload a profile
from a previously programmed flow processor, save a profile for later use and copy
a profile.
The following sections describe how to work with profiles.
Creating, Saving and Loading Proles
New
Save
Open
Figure 11: New, Load and Save buttons
Create a new profile by going to File>New or clicking the New button on the
toolbar. Save a new profile by selecting File>Save As and then choosing a save
location and filename. You can quickly save the file later by selecting File>Save,
or clicking the Save button on the toolbar. Open a previously saved profile by
selecting File>Open, or clicking the Open button on the toolbar.
Uploading a Prole
You can upload an existing profile from the EC80 Flow Processor and save it under
a different filename, then manipulate the data, yet still retrieve the old data if
necessary.
IMPORTANT
Always keep an OEM copy (original) of the profile, in case you want to restore the
factory configuration.
1. Click the Upload button in the toolbar of the main GUI screen. This retrieves
the prole currently stored in the ow processor (if previously downloaded)
and places all prole data from the ow processor in the GUI.
2. Click the File menu.
3. Click Save As.