Conguring Liquid Properties
Page 33 CXX-UM-03060-EN-01April 2019
CONFIGURING LIQUID PROPERTIES
Figure 26: Liquid properties tab
Use the Liquid Properties table to correct for changes in liquid viscosity,
compute mass flow rate via density tables and provide pressure versus viscosity
compensation.
Use the drop-down menu to select a liquid and display the liquid properties that
were factory configured.
If needed, create a new liquid by following these instructions:
1. Click the text of the drop-down menu to highlight the text.
2. Type a new liquid name.
3. Fill the viscosity table through use of the viscosity calculator or import a table.
4. Click the Save Liquid Tables button to Save the new liquid.
When you change the data in the table or re-name an existing liquid, the software
shows additional options in the menu bar:
Save Liquid Tables
Load Liquid Tables
Figure 27: Liquid tables buttons
The teal cylinders buttons appear for modification of the liquid registry. The
choice is:
Field Function
Load Liquid
Tables
Loads the currently stored liquid tables. The liquid tables are stored on the PC
Save Liquid
Tables
Overwrites any existing liquids stored on the PC and creates a group of liquids
based on what is saved
Delete Selected
Liquid
Deletes the currently selected liquid from the liquid registry. Liquids are selected
via the drop-down box or placing your cursor in the corresponding liquids table,
which activates the liquid and allows for deletion from the liquid registry
To Next Page
Loading...