COX EC80 - Real-time Monitoring

Real-time Monitoring
April 2019CXX-UM-03060-EN-01Page 38
The Bus ID information displays in the lower left corner of the main screen.
Figure 34: Bus ID information
To address an individual flow processor:
1. Click on the Current Bus ID # eld.
2. Change the value to correspond with the meter to be addressed.
3. Click the Upload icon on the toolbar of the main GUI screen.
The prole from the ow processor you addressed then populates the software
interface with the information stored in that particular ow processor.
4. (Optional) Click the Download icon to place another ow processor’s prole
into the currently selected ow processor.
REALTIME MONITORING
The EC80 Flow Processor outputs
real-time values via the established RS485
communication. Parameters and variables
can be viewed in the Status section of the
IFC15 GUI. The Status screen displays the
item (variable), the numerical value, the
engineering unit, and, if applicable, the
number of counts associated with that
particular variable.
You can select which parameters to view in
the options menu under the Report Display
tab. See “Report Display” on page43 for more
information. The Report Display is programmed
from the factory to display a core group of
variables. More variables can be applied to the
report format.
The status display is shown in Figure 35;
however it is necessary to follow the
instructions in “Real-Time Report Display” to
establish real-time update of the selected
variables.
Figure 35: Status section