Prole Programming
Page 27 CXX-UM-03060-EN-01April 2019
Standard vs. Auto-Viscosity
The EC80 Flow Processor, when used with a dual rotor turbine meter, incorporates
the ability to determine liquid viscosity directly from the turbine meter. The Auto-
Viscosity feature is applicable only to liquid viscosities at or below 40 cStk. If you
are unsure as to what range of viscosity you are operating over, please contact
Badger Meter, as a large database of liquid properties has been generated.
To select the Auto-Viscosity feature:
1. Click the Linearization tab on the GUI interface main screen.
Figure 16: Linearization tab
2. Click on the drop-down menu.
Figure 17: Liquid drop-down menu
3. Highlight Turbine (Liquid - Auto Viscosity) and click to select:
Figure 18: Auto Viscosity option
The Linearization table displays, showing the Auto-Viscosity feature enabled.
Remember, the liquid being metered must be below 40 cStks to use this feature. If
you’re unsure of the liquid’s viscosity, call Badger Meter at 877-243-1010.
To Next Page
Loading...