13
KEY FOB KEYCHAIN REMOTE
CHECKING SYSTEM STATUS
1. Press the button to light the LED to show the current
status of the security system.
2. The LED fl ashes red once to indicate that it has contacted
the system, then:
o Lights green for three seconds if the system is Disarmed
o Lights red for three seconds if the system is Armed.
o Lights orange for three seconds if the system is Not
Ready to be Armed (for example, if a door is open).
ARMING THE SYSTEM
From the key fob, you can arm your system in Arm Away
mode or Arm Stay mode (Arm Night mode must be
performed from the touchscreen control panel or the
Subscriber Web Portal.)
Arm Away
Press the button for about two seconds to arm the
system in Arm Away mode if the home will be unoccupied.
The LED fl ashes red once to indicate that it has contacted the
system, then lights red for one second. The exit delay starts.
Arm Stay
Press the
button for about two seconds to arm the system
in Arm Stay mode if there will still be people in the home.
The LED fl ashes red once to indicate that it has contacted the
system, then lights red for one second. The exit delay starts.
Introduction
The wireless Key Fob Remote gives you additional access
to your system in or near your home, enabling you to:
• Check the current system status (Armed, Disarmed,
or Not Ready).
• Arm the system in Arm Away mode or Arm Stay mode.
• Disarm the system before entering the premises.
• Send a silent Panic Alarm for police assistance.
CHECKING SYSTEM STATUS CHECKING SYSTEM STATUS
The wireless Key Fob Remote gives you additional access
to your system in or near your home, enabling you to:
• Check the current system status (Armed, Disarmed,
• Disarm the system before entering the premises.
• Send a silent Panic Alarm for police assistance.
To Next Page
Loading...
