16
WEB ACCESS
2
1
4
2
SECURITY
The website Summary tab indicates the overall status of
your security system.
To arm a disarmed system:
1. Click the Security Status header when it is in the
Disarmed state. Or select Security > Arm on the toolbar.
2. I f any security zones are currently in a fault condition,
preventing the system from being armed, you must
click the Turn Zone Off button for that zone before
arming the system.
3. Select the Arming Mode.
o Arm Away — Everyone is leaving the home.
o Arm Stay — There are still people in the home.
o Arm Night — Everyone is going to bed. This mode
works the same as Arm Stay except that there is no
entry delay period. If an entry/exit zone is opened
after the system is in the Arm Stay mode, an alarm
sounds immediately.
4. Enter your 4-digit Keypad Code.
5. Click Arm Now.
To disarm the system:
1. Click the Security Status Header when it is in the Armed
state. Or select Security > Disarm on the toolbar.
2. Enter your 4-digit Keypad Code, and click Disarm. To manage
other security settings, click Security on the toolbar.
Managing Keypad Codes
Keypad Codes are used to arm or disarm the system.
Multiple Keypad Codes can be assigned to track who
enters and leaves the premises.
To manage keypad access codes, select Security > Keypad
Codes on the toolbar to add a new access code or modify
current access codes.
3
1
5
To Next Page
Loading...
