Talos Operation and Service Guide
19
In essence, once the credit pulses for a bill have been sent, the bill will automatically be
accepted.
Activating the ESCROW signal and disabling the appropriate bill ENABLE signal after the
credit pulses for the bill have been sent will hold the bill in the escrow position. Keeping the
ESCROW signal active and re-enabling the processed bill ENABLE signal will accept the bill.
Disabling the ESCROW signal before enabling the processed bill ENABLE signal will return
the bill.
Note: For Talos Bill Acceptors which allow acceptance of higher denomination bills, Denom
1 ENABLE, Denom 2 ENABLE, and Denom 3 ENABLE all must be enabled to activate
acceptance of the higher denominations.
To Next Page
