CPI TALOS - TROUBLESHOOTING

Talos Operation and Service Guide
34
2
Another vending
component
Ensure the unit has been enabled, then check:
• Vending Machine Controller
• Coin manager and coin levels
• Inventory levels
• The door is locked properly
3
Lower housing
assembly
Check that the lower housing assembly is seated.
Ensure bill path is clean; see Cleaning section
5
Bill magazine removed
Reattach bill magazine
Continuous
Fast
Stacker Full
Empty the bill magazine
Continuous
Slow
Unit is defective
Replace the unit
TROUBLESHOOTING
These are some common, easy-to-solve issues that you may occasionally encounter, more
troubleshooting information can be found in the CPI Synq app:
If this happens
Try
The unit will not power up
Check Harnesses: Cables may be loose,
not properly connected or pins may be bent.
Check Source Voltage: Ensure that power
is being supplied to the bill validator.
The unit has power, but will not accept a bill
Ensure the unit has been enabled, then
check:
• Vending Machine Controller
• Coin manager and coin levels
• Inventory levels
• The vendor door is locked properly