CPS FA1000 SERIES - Full Cycle Mode

OPERATING INSTRUCTIONS FOR THE FA1000
The LCD will now read:
Push the + or - ARROW keys until the desired vacuum
time is programmed. Push the NEXT key.
The LCD will now read:
If oil injection is required, push the YES key.
Otherwise push the NO key. If the YES key is pushed,
you will be notied when to inject the oil.
The LCD will now read:
If desired, the units of measure can be changed at this
time. Push the CHANGE UNITS key.
CHARGE SELECT-
ED
2.00 LBS
* AVAILABLE REF.
24.00 LBS
CHARGE + >
CHARGE - >
CHANGE UNITS >
START >
QUIT >
From the MAIN MENU screen,
Push the FULL CYCLE key.
FULL CYCLE: The fully automatic mode is commonly used at quick car care service facilities where no leaks or repairs are required, but the
A/C system seems to be undercharged.
IMPORTANT: Before starting the recover of the refrigerant, a refrigerant identier should be used to to determine the type and purity of
the refrigerant. Failure to properly identify the refrigerant could potentially expose the user to danger from ammable refrigerants and
health hazards from toxic refrigerants. Cross contamination of refrigerants can also occur and would require special handling of the
refrigerant.
SELECT MODE
RECOVER >
EVACUATE >
CHARGE >
FULL CYCLE >
TANK REFILL >
00:05:00
TIME + >
TIME - >
NEXT >
QUIT >
SET EVACUATION TIME
OIL INJECTION?
YES >
NO >
12