Properly aligned retainer
and inner Polycord
holder.
Note: Assembly
has been turned over
for both better view of
alignment and to tighten
the at head screws.
Improperly aligned retainer
and inner polycord holder.
Note: The 3 holes of
the inner polycord holder do
not align with holes of the
retainer. Flex heads could not
be mounted to the machine in
this position!
Step 2
With the assembly in the same position as previous picture shows,
place the retainer on the screws insuring alignment is such that the
3 holes of the inner Polycord holder align with 3 of the 6 holes of
the retainer. See pictures below for examples of both proper and
improper alignment.
FLEX HEAD ASSEMBLY INSTRUCTIONS
24/7 Technical Support- Toll Free 1-877-472-8200
31
Concrete Polishing Solutions- G-250XTP Operator’s Manual
To Next Page
Loading...