Configuration Pages
The following table shows the navigation layout of the administration pages. Click on the tabs along the top bar to reveal the following
dropdown menus.
Getting Started Status Network Settings Internet System Settings
Enterprise Cloud Manager
Registration
First Time Setup
IP Passthrough Setup
Client List
Dashboard
GPS
Internet Connections
Routing
Statistics
System Logs
Content Filtering
DHCP Server
DNS
Firewall
Local Networks
MAC Filter/Logging
Routing
Connection Manager
Data Usage
WAN Affinity/Load Balancing
Administration
Device Alerts
Enterprise Cloud Manager
Serial Redirector
SNMP Configuration
System Control
System Software
Getting Started – Setup wizards for Enterprise Cloud Manager, First Time Setup, and IP Passthrough. NOTE: IP Passthrough Setup should not
be needed as LAN Port 2 is pre-configured.
Status – Displays various types of information about your router such as a list of clients that are attached to your networks (Client
List), the details of each Internet source your router is using (Internet Connections), and a map of your router’s location (GPS).
Very few changes can be made from this tab because the primary purpose is to display information.
Network Settings – Provides configuration options for the network(s), or LAN, created by your router. For example, you can enable a
VLAN (Local Networks) or set up rules to filter websites (Content Filtering).
Internet – Provides configuration options for the Internet sources, or WAN, used by the router. For example, you can set up a rule to
track how much data you are using per month on a modem (Data Usage) or set the APN for a modem (Connection Manager).
System Settings – Provides broad administrative controls. For example, you can upgrade firmware (System Software), or enable
remote management of the router (Administration).
To Next Page
Loading...
