AT Config Script: Enter the custom AT configuration scripts(s) to be applied to the modem at configuration time, one time shortly
after plug of the modem. Each script must be entered on a separate line. The interpretation of the script and associated response
will be logged so you should check the system log to make sure there were no error.
NOTE: Should not be used unless instructed to do so by your modem's cellular provider or by a support technician.
7.1.7 CDMA Settings
These settings are usually specific to your wireless
carrier’s private networks. You should not set these
unless directed to by a carrier representative. If a field
below is left blank, that particular setting will not be
changed in the modem. You should only fill in fields that
are required by your carrier.
• Persist Settings: If this is not checked, these
settings will only be in place until the router is
rebooted or the modem is unplugged.
• Active Profile: Select a number from 0-5 from
the dropdown list.
The following fields can be left blank. If left blank they
will remain unchanged in the modem.
• NAI (Username@realm): Network Access
Identifier. NAI is a standard system of identifying
users who attempt to connect to a network.
• AAA Shared Secret (Password):
“Authentication, Authorization, and Accounting”
password.
• Verify AAA Shared Secret.
• HA Shared Secret: “Home Agent” shared secret.
To Next Page
Loading...
