R1900 Series Router Quick Start Guide
Introduction
This document provides a brief overview of the R1900 Series router, discusses what’s inside the box, and provides basic setup and install instructions for the
router.
If you find information in this guide that is incorrect, misleading, or incomplete, we would appreciate your comments and suggestions.
NOTE: The Verify app includes many of the same instructions with an alternate order. This document supports the Verify app instructions. Use the Navigation
section below to locate the topics most applicable to troubleshooting your setup issues. For additional setup support, contact a professional installer or refer
to our Contact Us (https://cradlepoint.com/about-us/contact-us/) page.
Intended Audience
This article is intended for professional networking hardware installers. It provides basic knowledge and should be used only as a reference guide for
installing the R1900 Series router. Due to the unique nature of each installation, potential for RF exposure, and enhanced separation requirements,
customers must have a professional install their 5G hardware. This document is a reference guide and is intended only to provide best practices.
Refer to the Cradlepoint Product Disclaimer and Limitation of Liability section for further information.
Navigation
Use the following links to quickly navigate through the document.
R1900 Series Router Models
Before You Begin
Location Considerations
SIM Card for Wireless Connectivity
Router Communication and Data Usage
Required Tools for Setup
Setup
STEP 1: Check box for contents.
STEP 2: Remove the SIM door.
STEP 3: Insert an activated 4FF-sized SIM into the router.
STEP 4: Reinstall the SIM door.
STEP 5 (OPTIONAL): Connect to an RX30 managed accessory.
STEP 6: Attach the antennas.
STEP 7: Mount the router.
To Next Page
Need help?
General
