9
RECOMMENDED
ADJUSTMENTS
The adjustments have been performed on
the CX117 at the factory. However,
because of many variables involved with
shipping, we recommend that you verify
the following adjustments before the Test
Run.
1. Blade Tension
2. Blade Guide Adjustment
3. Stop Adjustments
TEST RUN
Once you have assembled and inspected
the machine it is then time to do a test run
and see if the machine powers up and
runs properly or not.
All tools and objects used for assembling
the machine should be removed and
cleared away before the test run.
Make sure that you have verified the
recommended adjustments listed before.
Fill the cutting fluid reservoir with cutting
fluid if not done so already.
Connect the band saw to the correct
power source.
Raise the band saw and close the feed
rate control knob to keep the saw in
place.
Start the band saw and keep your finger
close to the Emergency Stop button at all
times during the test run. The band saw
should run smoothly with little or no
vibration.
During the test run make sure the
start/stop button and all the safety
features on the mortiser are working
properly.
WARNING!
Make sure you have red and
understood the instructions given in
this manual and you are familiar with
the safety features of the machines,
before turning the machine on.
To Next Page
Loading...
