23) KEEPHANDSAWAYFROMCUTTINGAREA
24) STOREIDLETOOLS
When not in use,tools should be stored in dry, high or
locked-upplace--out of reachof children.
25) DONOTABUSECORD
Keepcord awayfrom heat,oil, andsharp edges.
26) OUTDOOREXTENSIONCORDS
Whentool is usedoutdoors, use only extensioncords
suitable for use outdoors, and so marked.
27) NEVERUSEIN AN EXPLOSIVEATMOSPHERE
Normal sparking of the motor could ignitefumes,
flammable liquids, or combustible items.
28) DRUGS,ALCOHOL,MEDICATION
Do not operatetool while under the i_fluence of drugs,
alcohol, or any medication.
INTRODUCTION
The GUIDEMASTERTM Router TablePush Shoehas beendesignedto helpcomplete many of the common wood-
working tasks performed on a router table. Although the push shoe can beused with any size of stock, its design
has beentailored for use with thin andnarrow stock. The product can be usedas a straight push shoe, as a miter
gauge,as a bit height gauge,to checkor.set fence offset distances,and as a set-up tool for making sliding dove-
tail joints.
USAGELIMITATIONS
To usethe push shoe as a miter gauge requires the removalof the bottom andside fencesandthe attachment of
the miter gauge.The conversion is very easyand should not take any longer than a coupleof minutes.
UNPACKINGANDCHECKINGCONTENTS
In order to simplify handling and to minimize any damagethat may occur during shipping, your router table push
shoe is packagedunassembled.Separateall partsfrom the packing materialsand check eachonewith the illustra-
tion and list of parts to make sure that all parts are accounted for before discarding any packaging material.
Warning! If any partsare missing or cannot be accounted for, do not attempt to assemble,or usethe push shoe
until the missing parts have beenobtained.Contact your local Searsretail outlet for replacementproducts or for
the missing parts,
ASSEMBLYINSTRUCTIONS
The following tools are required to assemblethis product:
1) A medium sizedflat bladed screwdriver.
2) A smallphillips screwdriver.
3) A smallcrescentwrench or pliers.
Readandobserve all instructions in your Router and RouterTableOwner'sManual beforeand when usingthis
product. Neverplacefingers in the path of the cutter,Always weareye protection which complies with current
ANSI StandardZ87.1 FAILURETO HEEDALL WARNINGSCOULDRESULTINSERIOUSBODILYINJURY.
To Next Page
Loading...
Need help?
General
