compliance with National and European regulations on
electrical safety.
The appliance must be connected to a 220 - 230V
50/60Hz 13amp fused switched socket outlet, installed
to the latest edition of the IEE regulations, using a 3
pin BS approved 13 amp fused plug for UK and in
compliance with National and European regulations on
electrical safety in other countries
Important! If the mains lead becomes damaged in any
way it must be replaced by a lead available from the
manufacturer.
Important! If any internal fuses become damaged or
fail in any way they must be replaced by a special fuse
available from the manufacturer quoting the
information written on the label adjacent to the
relevant fuse-holder.
2.4 Commissioning Procedure
A trained installation engineer must carry out the following
procedure before your machine is used for the first time.
Ensure that the electrical and water services to the machine
are connected correctly. Check for leaks in the water supply.
1. Open the door of your machine.
2. Ensure that the waste bucket is fitted correctly. Clip
the level probe and overflow pipes to the rim of the
bucket.
To Next Page
Loading...
