3. Cup Turret. Unbox the cup tubes and lid and fit in
place then fill with the correct size cups for the cup
catcher fitted to your machine. Allow the cups to drop
into the tubes directly from the packaging. DO NOT
touch the cups with your hands.
Important! Do not fill the tube directly above the cup
dispense position. Allow the cup turret motor to rotate
a full tube to the cup dispense position. Rotating the
cup turret by hand will damage the mechanism.
Note! If you are using paper cups, first inspect each
sleeve for damage to the cup rims. Damaged cups
must not be used.
4. The cup turret mechanism will index the first available
cups to the dispense position. Fill the remaining empty
cup stack with cups and replace the lid.
5. Press the Cup Test button [7], on
the Service Keypad and ensure that
a cup is ejected cleanly from the cup
drop unit.
6. All Models: The water inlet valve will open and the
heater tank will start to fill. Ensure that no water
overflows from the heater tank overflow pipe into the
waste bucket. Check the system for leaks.
To Next Page
Loading...
