Stringer Trailer Owner’s/Parts Manual
29
PN:90806-00 R090114
In the following section, we have listed many of the problems, causes and solutions to the problems that you may encounter.
If you encounter a problem that is diffi cult to solve, even after having read through this troubleshooting section, please
call your local Crary dealer. Before you call, please have this manual and the serial number from your machine ready.
TROUBLESHOOTING
Section
7
BEFORE YOU CALL
Please have the following information available:
Serial # ________________________ ______
PROBLEM REMEDY
If the table does not tilt up or down
Check the battery for a charge.
Make sure that the connections on
the battery are tight and there is good
contact
If the table brake does not engage.
Check the battery for a charge, and the
connections. (It also takes about 1/3
revolutions for the brake to function.)
If there is no click when the brake but-
ton is pressed.
Check for power to the drum at the
drum with a circuit tester. (You may
need to remove the wire nuts to check.)
If the brake button is pressed and there
is a click
Adjust the brake at the brake adjust-
ment port.
If the table does not want to go up or
down but the motor pulls down
or
The table raises but won’t lower or
vise versa
or
The solenoid seems to be stuck
Take a jumper wire and hook to positive
terminal or both and click solenoids
on pump several times on both sides
yellow and green wire. Do this without
running the pump.
To Next Page
Loading...
