Unigen Plus & Industrial Unigen - User technical documentation
-D page 2/19
History:
• Version A: May 2005 : initial document
• Version B: September 2005 : modification of the picture of the cover (P4).
• Version C: October 2006 : adaptation of the document for new hardware of the Unigen for Unigen Plus
A51M109 and Industrial Unigen.
• Version D: November 2006 : addition of the Modbus, Command mode and Mains paralleled functions.
Documentation List:
• A51Z090004 : technical documentation for Unigen Plus and Industrial Unigen.
• A51Z190104 : Application note : GCR/Unigen plus, wiring mains synchronisation.
• A51Z090100 : Application note : Generating set auto synchroniser and load sharer.
• A51Z190101 : Application note : Load shedding.
• A51Z190102 : Application note : Paralleling lines wiring for Carantec/Unigen Plus.
• A51Z190103 : Application note : Replacement of a powercon ‘DYN2-94026’ by a Unigen Plus.
• A51Z180006 : Application note : Procedure to download the complete firmware of a Unigen Plus.
• A51Z290001 : Application note : Mobil group
• A51Z090202 : Application pictures.
• A51Z090030 : Complete variable list with label, units and limits
A51Z1 ‘Unigen plus’
A51Z0 ‘MPS5.0’
A51Z2 ‘Industrial Unigen’
NOTE :
Read this entire manual and all other publications pertaining to the work to be performed before
installing, operating, or servicing this equipment. Practice all plant and safety instructions and
precautions. Failure to follow instructions can cause personal injury and/or property damage.
Contact your CRE dealer for course training.
To Next Page
Loading...
Need help?
General
