CRE Technology UNIGEN Plus - Unigen Unit Description; Unigen Core Functionality Overview

Unigen Plus & Industrial Unigen - User technical documentation
A51Z090004
-D page 4/19
1. Overview
1.1. Cover of the Unigen
Each terminals of the industrial Unigen are on the Unigen Plus.
Only for Unigen Plus.
1.2. Global function
• Automatic and Manual synchronization (‘sw5’ and ‘sw6’ configuration).
• Active load sharing in isochronous, droop mode or Command mode (for Unigen Plus).
• Reactive load sharing in isochronous voltage, droop mode or power factor fixed (for unigen Plus).
• Compatibility with all speed governors (‘sw2’ configuration) and AVR on the market.
• Remote speed control by potentiometer.
• Internal synch check relays, useful for auto and manual synchronization.
• Phase sequence protection.
• Load sharing with CAN plug and play (‘sw1’ configuration) or with paralleling lines(for Unigen Plus: ‘sw3’
configuration).
• Automatic load/unload.
• Reverse Kw relays.
• 2 analogue outputs (0-5V or 0-20mA/4-20mA) for Kw meter (‘sw4’ configuration).
• MODBUS RTU on serial port RS485 (for Unigen Plus) (‘sw8’ configuration).
• Command mode (for Unigen Plus).
• Mains Paralleled (for unigen Plus).
• For switches configuration see chapter 3 ‘Settings’.