How to fix Ender 3 S1/S1 Pro ABL issues
Alex Schladetsch
How to fix Ender 3 S1/S1 Pro/Plus ABL
issues
The symptoms that this resolves are:
- The bed mesh shows it being higher in front, and lower in the back, or higher on one side
than the other, or “ripples” or “waves” in the mesh.
- The bed mesh is just not accurate, resulting in poor first layers.
This guide is firmware agnostic.
After doing this, my bed levelling is 100% perfect, every time.
IMPORTANT: Take a screenshot of your current bed level mesh using Octoprint, Mainsail, Fluidd,
or whatever your favourite method is for doing so. We will be using this to compare, and verify
that we made a difference.
Here is my before and after, for an idea of the kind of improvement this makes:
Before:
To Next Page
Need help?
General
