1. Do not use the printer in any way other than that described herein in order to avoid personal inju or propey
damage;
2. Do not place the machine near any heat source or ammable or explosive objects. We suggest placing it in a
well-ventilated, cool and dustless environment;
3. We recommend the use of Creality Hyper plastic tray series laments, which have been tested extensively;
4. Do not use the power cable of other products during installation. Always use the attached power cable and be
sure that the power plug must be plugged into a grounded three-prong power outlet;
5. To avoid lament jam, do not use TPU or PVA(wet)and BVOH(wet) for printing;
6. Do not wear gloves or wraps while operating the machine to prevent entrapment of movable pas that could
cause crushing and cutting injuries to bodily pas;
7. To avoid lament spool getting stuck, do not use cardboard spool with untreated edges or cardboard spool that
are deformed as a whole;
8. Users should comply with the laws and regulations of the corresponding countries and regions where the equip-
ment is located (used), abide by professional ethics, pay attention to safety obligations, and strictly prohibit the use
of our products or equipment for any illegal purposes. Creality will not be responsible for any violators' legal liability
under any circumstance.
9. Tip: Do not plug in or unplug wires on a charged basis.
NOTES
To Next Page
Loading...
