Creality CR-X User Manual

CR-X 3D Printer User Manual
◆ This user manual is for standard CR-X.
◆ Because of software or hardware upgrades and model differences, new
revisions may not be listed in this guide.
◆ Please plug the power cord into a three-hole power jack.
◆ Detailed instructions for use are available on the TF card.
V.1.2

Creality CR-X Specifications

General

Build Volume	300 x 300 x 400 mm
Layer Resolution	0.1-0.4 mm
Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Extruder Type	Dual Extruder
Bed Leveling	Manual
Nozzle Quantity	2
Printing Technology	FDM (Fused Deposition Modeling)
Heated Bed	Yes
Connectivity	USB, SD card
Supported Materials	PLA, ABS, TPU, Wood

Summary

Device Assembly and Adjustment

Gantry Frame Installation Guide

Steps for assembling the gantry frame of the CR-X 3D printer using provided hardware.

Cable Connection Guide

Printer Screen Interface Navigation

Loading and Replacing Filament

Preheating for Filament Load

Instructions on preheating the printer nozzle and bed before loading filament.

Filament Feeding Technique

Step-by-step guide on how to insert filament into the extruder.

Filament Replacement Process

Bed Levelling Procedure

Manual Bed Levelling Steps

Detailed steps for manually adjusting the print bed to ensure proper levelling.

Levelling Adjustment Indicators

Visual indicators for correct, too high, and too low nozzle positions during levelling.

Software Setup and Installation

Creality Slicer Software Installation

First Print Preparation and Execution

3D Model Slicing Process

Steps for slicing a 3D model using the Creality Slicer and saving to TF card.

Dual-Color Print Model Merging

Initiating a Print Job

Instructions on how to select a model and start printing from the TF card.

Corrective Maintenance and Troubleshooting

Printer Troubleshooting Flowchart

A flowchart to diagnose and resolve common printing issues.

Component-Specific Maintenance