06
4.4 Cable Connection
X, E, Z-axis motor port
6pin (4 wires)
3pin (2 wires)
X-axis limit switch
A. Put the indication knob directly onto the motor shaft;
B1. Follow the yellow label on the 6pin (4 wires) port to connect the X-axis stepper motor;
B2. Follow the yellow label on the 6pin (4 wires) port to connect the E-axis stepper motor;
B3. Follow the yellow label on the 6pin (4 wires) port to connect the Z-axis stepper motor;
C. Follow the yellow label on the 3pin (2 wires) port to connect the X axis limit switch;
D. Plug in the power cord and toggle the switch to turn on the power.
Caution
●
Before powering on, be sure to select the correct
voltage mode according to the local grid voltage
to avoid burning out the power supply;
●
If the local power grid voltage is within 200-240V,
please dial the power supply of the machine to 230V
(it is 230V by default).
●
If the local power grid voltage is within 100-120V,
please dial the power supply of the machine to 115V;
115V
230V
B2
B1
C
D
B3
A
14
4.
Installing the 3D Printer
To Next Page
Loading...
